This Brivis Gas Heater Fan Motor is a direct replacement for your MPS30 V3 650W unit, designed to get your ducted gas heater running smoothly again. It’s a critical component for distributing warm air throughout the home, especially important during a cold snap.

I've seen plenty of these fail after years of hard work, especially after dusty seasons. Swapping out a faulty motor can prevent larger issues and restore comfort.

Best For

• HVAC service technicians
• Licensed gas fitters
• Residential heating maintenance teams
• Competent DIY owners maintaining their Brivis ducted gas heater

Compatibility

This fan motor assembly is specifically for Brivis Gas Heater models that use the MPS30 V3 650W motor, with Brivis Part Number 80019593. It comes as a complete assembly, ready for installation.

If you're running a different model, check fittings and specs before ordering.

Features

• Genuine Brivis replacement fan motor assembly
• Includes mounting plate for straightforward installation
• Comes with a pre-wired capacitor, simplifying wiring connections
• Rated at 650W for efficient air circulation
• Matches Brivis Part Number 80019593

Technical Specifications

What's in the Box

• 1 x Brivis Gas Heater Fan Motor (MPS30 V3)
• 1 x Motor mounting plate
• 1 x Pre-installed capacitor

Using It on the Job

1. Isolate Power: Always begin by switching off and locking out power to the Brivis heater at the main supply to prevent accidental startup.
2. Access & Disconnect: Carefully access the existing fan motor, noting all wiring connections. Take photos if needed. Disconnect the old motor's wiring.
3. Remove Old Motor: Unbolt and remove the faulty fan motor assembly from the unit.
4. Install New Motor: Position the new Brivis MPS30 V3 650W motor assembly, ensuring the mounting plate aligns correctly. Secure it with the appropriate fasteners.
5. Connect Wiring: Reconnect all electrical wiring, matching it to the original configuration. Double-check all connections for security and correct polarity.
6. Test Operation: Restore power and perform a test run of the heater, checking for proper fan operation, airflow, and any unusual noises. Monitor for a full cycle.

Limitations & Safety Notes

• Electrical work requires competent knowledge and adherence to AS/NZS 3000 (Wiring Rules). If unsure, call a licensed electrician or HVAC technician.
• This is an end-of-line product; supply is limited, so confirm availability before commencing a job.
• Ensure the fan blade is clean and balanced before connecting to the new motor to prevent premature wear.
• Only compatible with Brivis Gas Heater models designed for the MPS30 V3 650W motor (PN: 80019593).
• Always follow manufacturer's installation instructions and Safe Work Australia guidelines for working on heating appliances.

"When you're replacing a fan motor, always give the old fan blade a good once-over. Check for cracks, excessive dust build-up, or any signs of imbalance. A worn-out blade can quickly burn out your new motor."

Pair With

Consider pairing this motor with other Brivis Heating parts like new Brivis Control Boards or Brivis Ignition Modules if troubleshooting reveals further issues. A good quality multimeter is also essential for diagnostics.